Curtis FRF707 - Manuel (Page 7)

6
place it on a padded surface to prevent scratching it.
Remove the screws that hold the upper hinge pin,then transfer the hinge pin to the opposite
side,and tighten the screws.
3. Remove the plug buttons from the upper left holes as illustrated and transfer them to the
uncover hole at right side.
Lay the unit on its back against a solid surface at an angle of no less than 45
degree.Remove the screws that hold lower hinge,and then remove the lower hinge.
4. Remove the supporting leg and the screws that hold the lower hinge pin from the lower
hinge,and transfer them to the opposite side,and tighten the screws.
Remove the screws and left hinge,and the left leg.