Philips 10000104 - Manuel (Page 15)

If the user wishes to continue preparing other drinks the machine
will keep the “rinsing milk circuit” signal active.
After 20 minutes of inactivity, the machine requires the user to
perform a rinsing cycle as described in Step 7. If the machine is
turned off immediately after dispensing a milk product, the next
time the machine is turned on it will require the user to perform a
rinsing cycle.
Note: Before performing the “milk rinsing” function make sure to
do the following:
1. an adequate sized container is placed under the brew unit
2. the milk container with the cappuccinatore is filled with fresh
drinking water and inserted in the machine;
3. he water tank is full of fresh water.
After 14days from the first dispensing of
a milk-based beverage, the message
“milk circuit mashin3”is
displayed; it is advisable to clean the
milk circuits as shown on page 24.
After another 7 days, the machine comes
to a halt and the milk circuits have to be
necessarily cleaned.
Remove the milk container from the
machine; if it still contains milk, put it
back in the refrigerator for a
subsequent employment and use the
additional container. Rinse the
container with the cappuccinatore
and fill it with fresh water, place it in
the machine and press the^p> key.
In this phase the user cannot
intervene and must wait until the
cycle finishes. After this, the
machine returns to the main
menu.
Remove the container, rinse
and dry.
THIS PROCEDURE MUST BE PERFORMED FOR ALL
MILK PRODUCTS!
DISPENSING HOTMILK Fill the milkcontainer
Press t h e « key.
Select the hot milk and press the
key.
If desired, keep the^p> key
pressed until the desired quantity
is reached.
milk circuits as described for the latte macchiato (see page 12, icon 6 and following).