Chicago Electric PORTABLE FLUORESCENT WORKLIGHT 94761 - Manuel (Page 7)

English Page 7 94761 For technical questions, please call 1-800-444-3353.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
SPECIFIC SAFETy RULES
WARNING: When using outdoor use portable lamps, basic safety precautions
should always be followed to reduce the risk of fire, electric shock, and personal
injury, including the following:
REAd ALL INSTRUCTIONS
Use only three-wire outdoor extension cords that have three-prong groundling
plugs and grounding receptacles that accept the appliance’s plug.
Ground Fault Circuit Interrupter (GFCI) protection should be provided on the
circuit(s) or outlet(s) to be used for the wet location portable lamp. Receptacles are
available having built-in GFCI protection and are able to be used for this measure
of safety.
Use only with an extension cord for outdoor use, such as an extension cord
of cord type SW, SW-A, SOW, SOW-A, STW, STWOA, STOW, STOW-A, SjW, SjW-A,
SjOW, SjOW-A, SjTW, or SjTOW, SjTOW-A.
SAVE THESE INSTRUCTIONS
OPERATION INSTRUCTIONS
Press the Switch (16) once to turn the light on and again to turn the light off.
To adjust the angle of the Worklight, set the Worklight down and turn the round
adjusting knob on the side of the Worklight counter-clockwise.
Once loosened, the body of the Worklight can be adjusted to move up or down.
Turn the adjusting knob clockwise to the tighten the knob and lock the Worklight
body in place.
Bulb Replacement
Unplug the lamp and allow the bulb to cool completely.
Peel back the covers of the four Tap Screws (1) that are located on the top, bottom,
right and left sides of the Lamp Cover (2).
1.
2.
3.
1.
2.