Chicago Electric PORTABLE FLUORESCENT WORKLIGHT 94761 - Manuel (Page 4)

English Page 4 94761 For technical questions, please call 1-800-444-3353.
Maintain lights with care. Do not use a damaged light. Tag damaged lights “Do
not use” until repaired.
Check for misalignment or binding of moving parts, breakage of parts, and any
other condition that may affect the light’s operation. If damaged, have the light
serviced before using. Many accidents are caused by poorly maintained lights.
Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one light may become hazardous
when used on another light.
SERVICE
Light service must be performed only by qualified repair personnel. Service
or maintenance performed by unqualified personnel could result in a risk of injury.
When servicing a light, use only identical replacement parts. Follow instruc-
tions in the “Inspection, Maintenance, And Cleaning” section of this manual.
Use of unauthorized parts or failure to follow maintenance instructions may create
a risk of electric shock or injury.
GROUNdING
WARNING!
Improperly connecting the grounding wire can result in the risk of electric shock.
Check with a qualified electrician if you are in doubt as to whether the outlet is
properly grounded. do not modify the power cord plug provided with the tool.
Never remove the grounding prong from the plug. do not use the tool if the
power cord or plug is damaged. If damaged, have it repaired by a service facil-
ity before use. If the plug will not fit the outlet, have a proper outlet installed by
a qualified electrician.
GROUNdEd LIGHTS: LIGHTS WITH THREE PRONG PLUGS
Lights marked with “Grounding Required” have a three wire cord and three prong
grounding plug. The plug must be connected to a properly grounded outlet. If
the light should electrically malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user, reducing the risk of electric
shock.
(See Figure A.)
The grounding prong in the plug is connected through the green wire inside the
cord to the grounding system in the light. The green wire in the cord must be the
only wire connected to the light’s grounding system and must never be attached to
an electrically “live” terminal.
(See Figure A.)
4.
5.
6.
1.
2.
1.
2.