RCA VR270 - Manuel (Page 32)

Recording from A nother VCR
To copy (dub) tapes, connect the two VCR’s as shown
below. Use shielded audio/video cables (such as RCA
- AH002. AH005, or - AH036).
The connections from the recording VCR to your TV are
the ones you normally use. It’s best to play the original
tape on the same machine that was u.sed to record it (so
you don’t have to adjust the TRACKING buttons.)
Coaxial Antenna Cable*
(such as RCA #AH037)
CAUTION: The unauthorized recording of television
programs and other materials may infringe the rights
of others.
11 you have a TV Monitor/Recelver
with Audio/Video inputs, you
can also connect these jacks to
produce a slightly better picture
during playback.
Playback VCR
05;
' Q))
Audio/Video Cables*
(such as RCA AH002 or AH005)
your TV.) ^ .«mMi
iplional ^__
/
Optional
Audio/Video Cables*
(such as RCA AH002 or AH005)
j Recording VCR
(Connect this VCR to
your TV.)
‘Optional accessory available from your RC.A dealer.
Simplified Operating Instructions to Dub Tapes
1. Connect the two VCR’s as shown above. (Use
shielded audio/video cables such as RCA
#AH002. #AH005, or #AH036.)
2. Turn on TV.
3. Tune TV to VCR Channel (channer3 or 4).
4. Turn on both VCR’s. .......
5. Insert recorded cassette imo Playback VCR.
6. Insert blank cassette into Recording, VCR.
7. Press TV VCR button on remote control of
Recording VCR so !VCR| indicator is on. (This
allows you to watch the recording while it's in
progress.)
Note: If you want to watch another TV channel
on the lV w'hile you’re dubbing the tape, first
Pt^css ^e 7T t'CR button on remote control so
fbe jVCRI indicator is out and then use the TV’s
channel selecto." to select the channel you want
to watch on the T\’.
8. Sele^ channel 91 on the Recording VCR. The
jLINEi -ndicator will appear in the display.
(Press CHANNEL T or A button if channel 91
is programmed in the VCR’s Channel Memory
or press “9” then “1” on the remote control.)
Note: If the Recording VCR has a TUNER/
LINE switch, place it in the LINE position.
9. Select the desired tape speed on the Recording
VCR <SP, LP or SLP).
10. Rewind cassettes to the beginning if necessary^.
11. Place the Recording VCR into the record mode.
12. Press PLAY on the Playback VCR Ko start
playing the prerecorded cassette,
13. Adjust TRACKING buttons on Playback VCR if
necessary'. ■
Note; If the prerecorded cassette is not being
played on the same VCR that originally
recorded it. streaks may appear in the TV
picture. Simply press the TRACKING A or T
button on the Playback VCR to eliminate the
streaks.
14. If you want to edit out unwanted material, press
PAUSE on the Recording KCR while it is
recording. Press PA USE again to resume
recording,
.. . .
Note: Use the PAUSE button only for brief
pauses. If you want to pause for more than three
or four minutes, stop the VCR by pressing
STOP. When you are ready to resume, place the
VCR back into the record mode.
15. The TV does not have to be turned on to dub a
tape. You may turn off the TV if desired after
the recording has started,
16. Stop both VCR’s when the recording is finished.
30