Panasonic PanaFlat LC40 - Manuel (Page 7)

Precautions
1) Installation
«Install the monitor in a well ventilated place. Avoid exposing to direct sunlight, a
heater, or any other heat source. Heat will adversely affect the cabinets and the
parts inside.
•The AC Adapter will become warm in use. Place it where it is not exposed to
additional heat and where it will no damage any heat sensitive item. Do not place on
anything flammable.
• Position the display unit so that the holes in the cabinet will not be blocked during use.
• Keep the display unit away from the kitchen, bathroom, washing machine, or other
sources of exposed to water, steam or moisture.
• In order to use the display unit safely, use only the supplied AC line cord. The AC line
cord must be used with a properly grounded and polarized power supply socket. The
AC line cord supplied is for the USA (UL) and Canada (CSA) for use with the AC
Adapter supplied with the display unit. For use in other countries, make sure the AC
line cord meets the safety standards of the country.
• Place the AC line cord where it will not be subject to stress.
• Always use the accessory AC Adapter (Part Number TNQX010). Never use any other
AC adapter.
• Use only Panasonic provided accessories or the exact equivalent.
2) Usage
• Pulling on the AC line cord, DC Power Cable or VGA Signal Cable can damage the
display unit (monitor) and can cause the unit to fall and possibly cause personal injury.
• Receiving trouble.
If there is a television set or other display unit nearby, keep your display unit as far
away from it as possible. Mutual interference can cause image distortion or noise.
• Long exposure to rubber or vinyl products can stains the cabinet.
• Keep the monitor and AC Adapter from physical shock when moving. Be careful of the
Active Matrix-Liquid Crystal Display (AM-LCD). Be sure to disconnect the DC Power
Cable and the VGA Signal Cable from the display and the AC line cord from the AC
Adapter before moving the AC Adapter.
• Do not place anything on the monitor or AC Adapter.
• Also take good care of the power cable.
Do not place any objects on the power cable. Do not attempt to extend, shorten on tie
it into a knot.
3) Product Care
• Prior to cleaning your display unit, disconnect the DC power cord and the VGA Signal
Cable from the display unit. Prior to cleaning the AC Adapter, unplug the AC line cord
from the properly polarized and grounded socket, disconnect the other end of the AC
line cord from the AC Adapter, and disconnect the DC power cord from the display unit.
• Use a clean, soft, dry cloth to clean the outside of the monitor or the AM-LCD surface.
If the monitor or AM-LCD surface is very dirty, wet a clean, soft cloth with neutral
detergent (such as dishwashing detergent) and water, squeeze it tight until almost dry,
wipe the monitor or AM-LCD surface with it, and finish by wiping with a clean dry cloth.
Do not use any solvents.
• Do not rub or strike the AM-LCD with anything hard or harsh as this may scratch, mar
or damage the AM-LCD permanently.
• Do not use a chemical duster or polish-cleaner because it can adversely affect the unit
and peal the paint coat.
- 2 -