Vintage Cellars MPRO6WCM (Professional) - Manuel (Page 22)

TROUBLESHOOTING YOUR WINE CELLAR
22
Problem Possible Cause Remedy
Unit not cold enough.
Adjust temperatures (See “Set Tempera-
tures” on page 6).
• Control set too warm.
• Content temperature not stabilized.
• Excessive usage or prolonged door
openings.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Adjust temperature colder. Allow 24
hours for temperature to stabilize.
• Allow temperature to stabilize for at
least 24 hours, with minimal door
openings.
• Airflow must not be obstructed to
front grille. See “clearances” on
page 4.
• Check door alignment and/or adjust
or replace door gasket.
Unit too cold.
Adjust temperatures (See “Set Tempera-
tures” on page 6).
• Control set too cold.
• Door gasket not sealing properly.
• Adjust temperature warmer. (See
page 6, “set temperature”). Allow 24
hours for temperature to stabilize.
• Check door alignment and/or adjust
or replace door gasket.
No interior light. • Failed light bulb. • Replace light bulb, see page 21.
Light will not go out when door is closed. • Door not activating light switch. • Verify cabinet is level, refer to page 4
for leveling instructions.
• Verify the door is aligned properly,
refer to page 15 for instructions.
Noise or Vibration. • Unit not level. • Level unit, see “Leveling Legs” on
page 4.
Unit will not run. • Unit turned off.
• Power cord not plugged in.
• No power at outlet.
• Turn unit on. See “Start your Appli-
ance” on page 6.
• Plug in power cord.
• Check house circuit.
Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshooting
guide below. Locate the problem in the guide and refer to the
cause and its remedy before calling for service. The problem may
be something very simple that can be solved without a service
call. However, it may be required to contact your dealer or a
qualified service technician.
Electrocution Hazard - Never attempt to repair or perform
maintenance on the unit until the main electrical power has
been disconnected. Turning the unit control “OFF” does not
remove electrical power from the units wiring.
For Your Records
Date of Purchase
Dealer’s name
Dealer’s Address
Dealer’s City
Dealer’s State
Dealer’s Zip Code
Appliance Serial Number
Appliance Service Number
Date Warranty Card Sent (Must be
within 10 days of purchase).
If Service is Required:
• If the product is within the first year warranty period please
contact your dealer or call AGA MARVEL Customer Service
at 800.223.3900 for directions on how to obtain warranty
coverage in your area.
• If the product is outside the first year warranty period, AGA
MARVEL Customer Service can provide recommendations of
service centers in your area. A listing of authorized service
centers is also available at www.agamarvel.com under the
service and support section.
• In all correspondence regarding service, be sure to give the
service number, serial number, located on your product’s
serial plate, (see page 3) and proof of purchase.
• Try to have information or description of nature of the prob-
lem, how long the unit has been running, the room temper-
ature, and any additional information that may be helpful in
quickly solving the problem.
• Table D is provided for recording pertinent information
regarding your product for future reference.
Table D