Vintage Cellars MPRO6WCM (Professional) - Manuel (Page 15)

NOTE
NOTE
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Step 2: Remove door
Remove the top hinge pin from the hinge with an 1/8” allen
wrench. Remove the door by angling the top of the door out-
ward and lifting the door off the bottom hinge.
(See detail in Figure 6).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. To gain
access to the screw holes remove the door gasket by peeling up
and out of the channel.
Step 1: Verify door alignment
Verify that the door is aligned correctly with the cabinet prior
to fabricating the custom panel. Failure to do so could result in
mis-alignment of the custom panel with the hinge bracket. The
door should be parallel to the sides and top of the refrigerator.
If alignment is necessary the door may be adjusted by loosening
the 2 screws which secure the upper and/or lower hinge adapter
brackets located on the top and bottom of the door, and adjust-
ing the door side to side. Use a 5/32” allen wrench for this pro-
cedure. (See Figure 6 below). When finished aligning the door,
tighten the screws securely.
Door should be
parallel to top
and sides of
refrigerator.
15
Step 4: Cut overlay panel
Depending on the wine cellar model cut the overlay panel to the
dimensions shown. Use Figure 7 and Table A for solid door mod-
els or use Figure 8 and Table B for glass door models.
H
W
Front of
overlay
panel
For overlay with lock option panel thickness to be
3/4” (19mm) maximum to 5/8” (16mm) minimum.
Weight of the overlay panel should not exceed 20 pounds (9.1
kilograms).
For the door to close properly, it is necessary to maintain a mini-
mum space of 9/32” (7mm) between the door and cabinet flange
(See Figure 6). This space can be adjusted by adjusting the top
and bottom hinge adapter brackets.
Figure 6
Hinge adapter bracket lo-
cated on top and bottom of
the door.
Remove top hinge
pin to remove the
door.
9/32”
(7mm)
Model W H
30WCM
14 5/8”
(37.1cm)
30 5/16”
(77cm)
61WCM
23 5/8”
(60cm)
30 5/16”
(77cm)
Figure 7
Solid Door Models
Solid Door Models
Table A