Vintage Cellars MPRO6WCM (Professional) - Manuel (Page 19)

61WCM WINE CELLAR FEATURES
Insert Wine Bottles
The four (4) pull-out shelves each hold eight (8) bottles. See
Figure 17 for typical wine bottle spacing. Care should be taken
when storing extra tall bottles in the wine cradle at the bottom
of the compartment because they may prevent the door from
closing.
Loading Tips and Suggestions
Two (2) magnums can be placed in the bottle cradle as long as
they are positioned horizontally.
The bottles on the top rack directly under the light will be
exposed to a slightly higher temperature when the light is on.
Position your wines accordingly and REMEMBER TO TURN OFF
THE LIGHT WHEN IT IS NO LONGER NEEDED.
Keep wines that you plan to use for everyday drinking and enter-
taining on the front half of the racks where labels are completely
visible. Place wines for aging or longer term storing in the rear.
Pull-out Racks
The four (4) pull-out wine racks may be pulled out approximately
seven and a half (7.5) inches to facilitate adding or removing
bottles. DO NOT lean on or press down heavily on the wine
shelves. Doing so may damage the shelves and the wine bottles
stored on them. Pull the wine racks out gently and carefully to
minimize unsettling your wine collection. Avoid pulling out more
than one rack at any time to maintain stability.
Single Bottle Racks
The single level roll out racks allow you to easily view and access
your inventory without disturbing other bottles (see Figure 19).
Figure 18
Figure 19
19
Front Bottles (Necks Facing Rear)
Rear Bottles (Necks Facing Front)
Figure 17