Sony CMT-M11C - Manuel (Page 7)

Step 3: Presetting
radio stations
You can preset up to 20 FM stations and 10
AM stations. Use the buttons on the remote to
do this operations.
4
5 . 7
Number
buttons
3 . 6
1
Press BAND repeatedly until the
band you want appears in the
display.
AM
2
Press TUNING MODE repeatedly
until "AUTO" appears.
3
Press TUNING + or - to tune in the
station you want to store.
The frequency indication changes and
scanning stops when the system tunes in
the station. "TUNED" and "STEREO"
(for a stereo program) appear.
4
Press EDIT/NO until "Frq-
Memory?" appears.
5
Press YES.
The preset number flashes in the display.
6
Press TUNING + or - and select the
preset number you want.
7
Press YES.
The station is stored.
8
Repeat steps I through 7 to store
other stations.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
"MANUAL" appears in step 2, then press
TUNING + or - to tune in the station.
To change the preset number
Start again from step 1.
To directly select preset numbers
You can quickly select the preset numbers by
pressing the corresponding number buttons. Before
operating it switch MD/CD/TUNER to TUNER.
When you select preset number over 11 press >10
first, then enter the corresponding digit.
Example: To select preset number 20, press >10,2,
and 10 in this order.
To change the AM tuning interval
(Except for the North American and
Middle Eastern models)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval to lOkHz (or 9 kHz), press BAND
repeatedly until "AM" appears first, then turn off
the power. While holding down YES, turn the
power back on.
When you change the interval, the AM preset
stations will be erased. To reset the interval, repeat
the same procedure.
Note
The preset stations are retained for a week even if
you pull out the AC power cord or if a power failure
occurs.
if AT