Sony MDS-JB920 - Manuel (Page 48)

Editing Recorded MDs
Labeling tracks and MDs with the remote
NAME
CHAR
■**/»■ —HGB52>
v9'-
0-VÎÎ'-.
'.2) CD CD C
CD ,
ÜDZD
o à O f+)
j OD ® ^ O ^
MENU/NO
. Alphabet/number
buttons
CLEAR
• NUM
4 Repeat Step 3 until you have entered the entire
title.
If you entered the wrong character
Press ◄◄ or ►► until the character to be correcteci
starts flashing.
Press CLEAR to erase the incorrect character, then
enter the correct one.
5 Press NAME again.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press MENU/ NO or ■.
1 Press NAME repeatedly until a flashing cursor
appears in the display, then do the following:
To label Make sure that the deck is
A track Playing, pausing, recording the
track to be labeled, or stopped after
locating the track to be labeled
An MD Stopped with no track number
appearing in the display
Select the character type as follows:
To select Press
Uppercase letters CHAR repeatedly until "Selected
AB" appears in the display
Lowercase letters CHAR repeatedly until "Selected
ab" appears in the display
Numbers NUM repeatedly until "Selected
12" appears in the display
Press an alphabet/number button to enter a
character.
After you enter a character, the cursor shifts
rightward and waits for the input of the next
character.
You can change the character type at any time
during Step 3 (see Step 2).
Changing an existing title
1 Press NAME, then do the following:
To change Make sure that the deck is
A track title Playing, pausing the track whose
title is to be changed, or stopped
after locating the track whose title
is to be changed
A disc name Stopped with no track number
appearing in the display
2 Hold down CLEAR until the current title is
erased.
3 Enter the new title.
Do Steps 6 to 9 of "Labeling Recordings" on pages
45 and 46, or Steps 2 to 4 of "Labeling tracks and
MDs with the remote" on this page.
4 Press NAME.
(Continued)
47"