Sony MDS-JB920 - Manuel (Page 35)

■ =hr-‘
Controlling a Separately Available Sony CD Changer
Hooking Up the System
When \ oii connect a Sonv CD changer with a
CONTROL A1 jack to the MD deck using a control A1
cable,
YOU can operate the CD changer using the
controls on the MD deck or the supplied remote (Mega
CD Contrcsi-Tunction).
Hook up the MD deck to an amplifier and a CD
changer as follows. Be sure to turn off the power of
each component before connection.
Notes
• You can use the Mega CD Control Function onlv when the
deck is connected to a CD changer. This function does not
support single-disc CD players.
• The displays and operations may differ depending on the
connected CD changer.
Signal flow
What cords will I need?
• Audio connecting cords {only two supplied) (3)
Optical cable (supplied) (1)
■din=^= ígnita-
Coaxial digital connecting cable (not supplied) (1)
-on
• Control A1 cable (not supplied) (1)
“=<1 lin I'tfll n=”
Hookups
Connecting the MD deck and a CD changer to an
amplifier
Connect the amplifier to the LINE OUT jacks on the
CD changer and the LINE (ANALOG) IN /OUT jacks
on the MD deck using the audio connecting cords (only
two supplied).
Make sure to match the color-coded cords to the
appropriate jacks on the components: red (right) to red
and white (left) to white. Be sure to make connections
firmly to pre\'ent hum and noise.
CD changer
;. UNE n
; OUT
MD deck
Connecting a digital cable to the CD changer and
MD deck
You can make a digital recording from a CD to an MD
by connecting the CD changer and MD deck with an
optical cable or a coaxial digital connecting cable.
When using the optical cable
Take the caps off the connectors and then insert the plugs
parallelly until they click into place.
Be sure not to bend or tie together the optical cable.
MD deck CD changer
I digital '
©
COAXIAL OPTICAL ■
OUT OUT
® 1^ j y
You can connect the optical cable
to either OPTICAL INI or IN2
r Signal flow
34"