Assign an ip address, When using the operator panel – Dell 5130cdn Color Laser Printer Manuel d'utilisation
Page 75
4. Select Reports.
5. Click the Start button in the Printer Settings.
The printer settings report is printed.
Assign an IP Address
NOTE:
When you assign an IP address manually in IPv6 Mode, use the Dell Printer Configuration Web Tool. To
open the Dell Printer Configuration Web Tool, use the link local address. (To check a link local address, see
"
Print and Check the Printer Settings Page
.")
An IP address is a unique number that consists of four sections that are delimited by a period and can include up to three
digits in each section, for example, 111.222.33.44.
Assigning an IP address already in use can cause network performance issues.
NOTE:
Assigning an IP address is considered as an advanced function and is normally done by a system
administrator.
NOTE:
Depending on the address class, the range of the IP address assigned may be different. On Class A, for
example, an IP address in the range from 0.0.0.0 to 127.255.255.255 will be assigned. For assignment of IP
addresses, contact your system administrator.
When Using the Operator Panel
For more information on using your operator panel, see "
."
1. Turn on the printer.
The Ready to Print appears.
2. Press Menu button.
3. Press
button until Admin Menu is highlighted, and then press
(Set) button.
4. Ensure Network is highlighted, and then press
(Set) button.
5. Press
button until TCP/IP appears, and then press
(Set) button.
6. Press
button until IPv4 is highlighted, and then press
(Set) button.
7. Ensure Get IP Address is highlighted, and then press
(Set) button.
8. Press
button until Panel is highlighted, and then press
(Set) button.
9. Press
button until IP Address is highlighted, and then press
(Set) button.
10. The first digit of the IP address is highlighted. Press
or
button to enter the numbers for the IP address.
11. Press
button.
The next digit is highlighted.
and
to enter all of the digits in the IP address, and then press
(Set) button.
13. Press
button until Subnet Mask is highlighted, and then press
(Set) button.
to
to set Subnet Mask, and then press
(Set) button.