Garland ED SERIES ELECTRIC COUNTER UNITS - Manuel (Page 10)

Part # 4521653 Rev 1 (03/05/13) Page 10
Broilers – Models: ED-15B,
ED-30B & ED-42B
Wall Clearance
Do not install appliance closer to a wall of combustible
material than:
Back 9” (229mm)
Sides 9” (229mm)
Supply Connection
For supply connection, use wire suitable for 90°C (194°F).
Electrical Connection
A knockout is provided near the front left side of the unit
located behind the control panel. To view knockout, loosen
the two acorn nuts and hinge control panel downward. The
terminal block is also located in this area.
The cable entrance is located on the right side when facing
the rear of the unit. The cable is fed towards the front
through a wire way.
Controls
Infinite switches are used to control the elements.
HI to 5 - High heat
5 to 3 - Medium Heat
3 to LO - Low Heat
Setting of switches between the numbers will give
intermediate heat. Switches are reversible and may be
turned right or left.
Food Warmers – Models ED-15W & ED-15WP
Wall Clearances
Do not install appliance closer to a wall of combustible
material than:
Back 1” (25mm)
Sides 1” (25mm)
Supply Connection
NOTE: Applicable to Model ED-15W only. Model
ED-15WP is a 115 volt unit supplied with a grounded cord
and plug.
For Model ED-15W, use a wire suitable for 90°C (194°F).
Electrical Connection
NOTE: Applicable to Model ED-15W only.
A knockout is provided near the front left side of the unit
located behind the control panel. To view knockout, loosen
the two acorn nuts and hinge control panel downward. The
terminal block is also located in this area.
The supply cable entrance is located on the right side when
facing the rear of the unit. The cable is fed towards the front
through a wire way.
Controls
Infinite switches are used to control the elements.
HI to 5 - High Heat
5 to 3 - Medium Heat
3 to LO - Low Heat
Setting of switches between the numbers will give
intermediate heat. Switches are reversible and may be
turned right or left.
Operating Instructions
ED series food warmers are supplied with a removable tank
assembly. Fill tank with 1-1/4” (32mm) to 1-1/2” (38,mm) of
water.
While not supplied with the food warmer it uses a 200
series of Gastronorm cafeteria pan and any arrangement
of 200 series pans in various sizes may be used. Individual
preference of the operation will determine sizes of inserts
to be used. Pans may be purchased from your kitchen
equipment dealer.
CAUTION: Do Not Allow The Tank Assembly To Run Dry.
ED Series food warmers are wet type only. Operating these
units dry for extended periods may cause the tank assembly
to warp and void the warranty.
INDIVIDUAL MODEL INSTALLATIONS continued