Operating your espresso/cappuccino machine cont’d – Breville ESP8XL Manuel d'utilisation

Page 6

Advertising
background image

11

10

OPERATING YOUR ESPRESSO/CAPPUCCINO MACHINE cont’d

Always ensure that the frothing

attachment has been firmly

pushed onto the steam wand.

For best results use fresh

cold milk (light milk will

froth easier).

Always clean the steam wand

and froth enhancer after every

use (refer to care and cleaning).

If brewing more coffee straight

after using the steam function,

set the selector control to the

‘espresso’ position to run a

small amount of water through

the brewing head for a few

seconds without the filter

holder in place. This will

prepare the system for

optimal brewing temperature.

LIQUID SHOULD NOT BE ALLOWED TO RUN OVER THE TOP OF THE

FROTH ENHANCER, OTHERWISE IT WILL NOT FUNCTION. TO AVOID

SPLATTERING OF HOT MILK, DO NOT LIFT THE STEAM NOZZLE

ABOVE THE SURFACE OF THE MILK WHILE FROTHING. ENSURE

THE SELECTOR CONTROL IS IN THE ‘OFF’ POSITION BEFORE

REMOVING THE FROTHING JUG.

HOW TO FROTH MILK FOR A
CAPPUCCINO OR LATTE

The Breville Café Roma comes complete

with a frothing attachment for easier

frothing of milk. The first step in making a

cappuccino/latte is to make a short espresso

(see "Brewing Coffee"). Then:

1. Fill the stainless steel frothing jug

1

3

full

with cold milk.

2. As soon as the orange ‘heating’ light

turns off, plunge the steam wand into jug

of milk so that the main head of the froth

enhancer is immersed into the milk.

3. Set the Selector Control to the

‘STEAM’ position.

4. Gently move the frothing jug in a circular

motion around the froth enhancer.

5. When the milk has begun to increase in

volume, immerse the froth enhancer deeper

into the milk to further heat the milk.

6. The amount of froth desired may vary by

individual. The stainless steel frothing jug

will gradually become hot; be sure to hold

the handle or use a towel to avoid a hot

jug. Once the froth is to your liking switch

the Selector Control to the ‘Off’ position

to stop the steaming function before

removing the jug. This will ensure that

you don’t burn the milk.

7. Add the steamed milk to each cup of

freshly brewed espresso coffee and spoon

on the frothed milk in the following ratios:

Cappuccino

1

3

espresso,

1

3

steamed milk,

1

3

frothed milk

Latte

1

3

espresso topped with steamed milk and

approximately 4" (10cm) of frothed milk

(traditionally served in a glass)

OPERATING YOUR ESPRESSO/CAPPUCCINO MACHINE cont’d

THE METAL PARTS OF THE FILTER HOLDER MIGHT STILL BE

VERY HOT. COOL DOWN THESE PARTS BY RUNNING UNDER COLD

WATER. MAKE SURE YOU USE THE FILTER RETAINER CLIP WHEN

DISCARDING THE COFFEE GROUNDS.

Advertising