Philips 10002684 - Manuel (Page 49)

46 error Codes
gUIDE mESSAgE THAT APPEARS HOW TO REmOVE THE mESSAgE
restart the machine turn off and after 30 minutes turn the machine on again
to restore normal operation.
call assistance contact an authorized service center.
insert drip tray insert drip tray under the brew group.
close coffee bean container Close the coffee bean hopper cover to be able to brew
any beverage.
add ground coffee Add one scoop of pre-ground coffee to the pre-ground
bypass doser.
insert brew group Insert the brew group in its place.
insert dreg drawer insert the dregdrawer.
empty dreg drawer remove the dregdrawer and empty the grounds in an
appropriate container.
note: the dregdrawer must be emptied only when the
machine signals to do so, and when the machine is
turned on.
Emptying the drawer with the machine turned off does
not allow the machine to register that it has been
emptied.
close side door close the side door of the machine.
refill water tank Refill the water tank with fresh drinking water.
empty drip tray open the side door and empty the drip tray under the
brew group.
insert the milk container insert the milk container in its compartment.
prime the machine Press on the display in order to proceed with manually
priming the water circuit. The machine performs an
automatic attempt to prime the circuit. if this attempt
does not perform correctly you must proceed with these
instructions.
circuit priming failure contact an authorized service center.
the descaling cycle has not been completed
correctly
Repeat the operation as described in the descaling
section.
milk rinsing See page 13 and 28.
milk cleaning See page 13 and 29.
prime the circuit Set the SBS dial to the position shown on the display
screen, and proceed with cleaning the brew group. Then,
prime the circuit once again.