Philips 10002684 - Manuel (Page 46)

43
1 2 3
5 4
press to open the service door.
The brew group must be cleaned at least once a week.
Lubricate the brew group after approximately 500 brewing cycles. The brew group lubricant may be
purchased directly from saeco or any authorized service center.
Wash the brew group with warm water.
WARNINg! Do not wash the brew group with detergents that can compromise its correct operation. Do
not wash in the dishwasher.
Wash any coffee residues from
the brew group.
Press the PUSH button to remove
the brew group.
Make sure the brew group is
ready to be put back in. The two
references must align.
CLEANINg THE bREW gROUP
Wash the upper fi lter with
running water.
7 8 9
the lever on the rear part of
the group must be in contact
with the group base.
6
make sure the components are in
the correct position. the hook
shown must be in the correct
position; to check its position,
fi rmly press the “PUSH” button.
Lubricate the brew group guides
only with the supplied lubricant.
Apply the lubricant evenly.