Bosch MistCare Nexxt Series - Manuel (Page 18)

18
Program selection
For optimum drying results your dryer offers several program groups and
additional options.
Automatic programs include Regular/Cotton and Permanent press. Program selection is
based in part on the laundry fabric type. These programs are controlled via moisture sensors.
Program time is determined by the measured degree of moisture in the laundry and on the
degree of dryness selected (e.g. Damp dry, Regular Dry, Extra Dry).
Time programs run for a user specified length of time. The Air fluff/No heat timed cycle uses
ambient air (room temperature) without a heat supply and runs for 20 minutes.
Special programs are custom designed for specific types of fabric such as wool or jeans.
Wool or woolen products should only be dryed using the dryer rack.
During this cycle a small amount of water is sprayed into the drum while tumbling with heat. This process is repeated, followed by additional
tumbling and a brief cool down period. The heat level and time are preset for these programs.
Note: Results may vary with fabric type. Garments that are 100% cotton and have wrinkle-resistant finish may give better results.
If the nozzle stops spraying during one of the MISTCARE

cycles (symptoms would be water is not seen spraying into drum, clothes are less
wrinkle-free than they customarily are with this function) check to be sure the nozzle is not clogged. Lint may accumulate to block the nozzle tip or
hard water may cause buildup on the nozzle (see page 26).
MISTCARE

cycles are best suited for smoothing out wrinkles and reducing odors.
These programs should be used with loads consisting of three to four items made of
wrinkle free cotton, cotton/polyester blend, cotton knit pullovers or synthetics.
Option Buttons
Delicates low temp.
Press the "Delicates low temp." button
for temperature sensitive textiles.
Observe the care information or
symbols on the textiles. The
temperature of the drying process is
reduced, the drying time is extended.
ECO
e
Your dryer has an energy savings"
ECO option. This option is used only
with cotton and permanent press
automatic programs. Less heat is
applied, and drying time is extended.
Press the option button prior to starting
an automatic program.
i The energy savings" of the ECO
e
program is affected by the load
size, textile type and climatic
conditions.
i Combining with the Delicates low
temp. button can produce more
savings.
Signal
500 Series
Your dryer outputs different signals for
certain events. You may enable or
disable the signal by simultaneously
depressing the buttons shown. The
following audible tones will be
generated indicating the status of the
appliance.
Signal Type
Start Short tone
End Sequence of short
tones
MalĆoperation Sequence of long tones
Warning of
malfunction
Sequence of long tones
i The signal
Warning of malfunction" is active
regardless of whether or not the
signal has been disabled.
LED Indicators of Program
Sequence
The dryer uses an electronic scanning
system for all programs except the time
programs . A moisture sensor
continuously checks the moisture in the
laundry. Drying ends automatically as
soon as the selected degree of dryness
has been reached.
The drum continues to rotate at
specific intervals for one hour to
prevent creasing.
The current degree of drying and the
level reached during the program
sequence is indicated via indicator
lights (Drying, Damp dry, Regular dry,
Wrinkle block).
i If the indicator light Wrinkle block"
illuminates when the program
selector is in Off-Position - turn off
the circuit breaker and call for
customer service!