Bosch MistCare Nexxt Series - Manuel (Page 16)

16
OPERATING INSTRUCTIONS
Before using
d WARNING
Before using your dryer, read and
follow all installation and operating
instructions.
Panel
Delicates low temp: Press for
temperature-sensitive textiles
(e.g. acrylic fibers). The
temperature of the drying process
is reduced, the drying time is
extended correspondingly.
ECO
e
: Press for additional
energy savings (use only for cotton
and permanent press auto
programs). Press the option
button prior to starting an
automatic program.
C Signal (500 Series)
Press the two option buttons at
the same time to enable an
acoustic signal that indicates the
end of the program (see page 46).
The 800 Series signal is set on the
LCD menu (see page 20).
D Display
500 Plus Series
Indicates the estimated
remaining time of programs.
800 Series
Indicates the settings of the
additional options and the
estimated remaining time of
programs. (See page 20)
Additional Options
Menu selects one of the
additional options
Select changes the settings of
the selected option
A Start/Pause
button
Starts, interrupts and
ends the drying process.
G Program Selector
Switches the machine on and off and
selects the program (see page 18). Can be
turned in both directions.
To switch off the dryer, rotate the program
selector to Off".
F Indicator Lights
LED'S light up in sequence to show the
current moisture state of the drying
process.
Wrinkle block - at the end of the drying
program an acoustic signal sounds and
the Wrinkle block LED lights up. The
drum rotates at specific intervals for one
hour to prevent the laundry from creasing
(see page 18 ).
B Option buttons
Add functions to the program
selected. The option button
LED is lit when the option is
selected. Press the option
button again to turn the
option off (LED turns off).
E Lint Filter LED
Blinks as a reminder to
clean the lint filter before
and after use. Lit (steady)
when the door is opened
during a program, or in the
event airflow is reduced
enough to create an E:01 error
(see troubleshooting guide,
page 25).
Start/Pause LED Status
Lit Red: Program is
running and "Pause" can
be activated.
Blinking: Settings can
be changed, the drying
cycle can be started, or
program is in Pause"
mode.
Not Lit: Program is
finished or there is no
program selected.
B
C
D
F
G
A
E