Whirlpool WET3300XQ - Manuel (Page 22)

22
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
6.
Check for leaks
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with shipping strap removed earlier.
7.
Secure drain hose
4.5"
(113 mm)
4.5"
(113 mm)
4.5"
(113 mm)
4.5"
(113 mm)
4.5"
(113 mm)
Laundry Tub Standpipe Wall
CONNECT VENT
Connect vent to exhaust outlet
1.
Move washer/dryer to final location
2.
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
Move washer/dryer to final location, taking care not to crush
or kink vent.
After washer/dryer is in place, remove corner posts and
cardboard from under washer/dryer.
CONNECT INLET HOSES
Connecting from front
(for closet or recessed
area)
Connecting
from rear
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(114 mm)