Australian Monitor Zone Revolution - Manuel (Page 6)

Network Connection:
When the Zone Revolution software is run for the fi rst
time a default connection page is launched. By clicking
File > Settings it is possible to make this page not
appear and have the software simply connect to the
last known good connection. This allows the installer to
have the software confi gured and connect automatically
as the PC starts up.
The initial connection page also allows the user to
update fi rmware and change the IP address within the
Zone Revolution hardware. This can all be done from
the Setup drop menu within the title bar.
All Zone Revolution units have a default IP address of
192.168.178.178.
Connection For the First Time:
It is suggested that when connecting to the
Zone Revolution for the fi rst time that a crossover cable
is used straight between the unit and your PC. You
will then need to change your network adapter to
have an IP of 192.168.178.170 with a subnet of
255.255.255.0. Then all you will need to do is open
the Zone Rev software and connect. Once you have
connected for the fi rst time you can set the units
IP address or change it to DHCP.
Zone Control Page:
The main page of the Zone Revolution software allows
the user to adjust all routing for a particular zone.
In terms of DSP the zone routing page is after the
input source processing but before the zone’s output
processing. All inputs within the Zone Revolution are
available on all outputs. This page gives the user
access to adjust basic functions such as volume,
panning and mute controls.
PAGE 4 ZONE REVOLUTION QUICKSTART MANUAL
SETUP