Pitco Frialator SGM34 w/o Filter System - Manuel (Page 9)

7 L20-281 rev 1 (05/29/13)
WARNING
The power supply must be disconnected before servicing or cleaning the
appliance.
Preparing the filter for use:
· Slide drawer forward until it stops.
· Grasp the Left and Right handles of the Paper Retaining Frame and lift upward to remove it.
· Remove the filter paper or pad by folding the edges inward so that the debris is collected.
· Lift the Paper Support Screen out of the pan.
· The Pan, Paper Support Screen and Paper Retaining Frame can now be cleaned.
NOTE: Be sure that the filter pan is free of any debris which could cause the paper and hold down ring
not to seat properly.
· Place the Paper Support Screen in the bottom of the pan.
· Place filter Paper or Pad over screen making sure that there is an equal amount of excess paper on
each side.
· Place the Retaining Frame on the paper or pad making sure that all edges are being pressed down
evenly.
· Slide filter drawer back under fryer making sure that the oil return pipe locates into its mating
connection.
CAUTION:
Be careful when using the clean out rod. Damage to the drain valve may result.
WARNING:
Hot shortening can cause severe injury. Take care when filtering or disposing of hot shortening.
Protective gear such as gloves, apron, face shield and sleeves should be worn.
ENGLISH