Pitco Frialator SGM34 w/o Filter System - Manuel (Page 6)

4
L20-281 rev 1 (05/29/13)
TYPES OF FIRE EXTINGUISHERS
AND DETECTION EQUIPMENT
CO
2 ANSI/UL 154 ANSI/NFPA 12
DRY CHEMICAL ANSI/UL 299 ANSI/NFPA 17
WATER ANSI/UL 626 ANSI/NFPA 13
FOAM ANSI/UL 8 ANSI/NFPA 11
SPRINKLERS ANSI/UL 199 ANSI/NFPA 13
SMOKE DETECTORS ANSI/UL 268 ANSI/NFPA 72
FIRE DETECTION THERMOSTATS ANSI/UL 521 ANSI/NFPA
Gas pressure check
Gas pressure should be measured at the burner manifold and should match the pressure requirement
listed on the data plate mounted on the inside of the fryer door..
LIGHTING INSTRUCTIONS
a. Fill kettle before lighting.
b. Turn combination gas valve knob to “ON” position.
c.
Computer Controller: Press the button on the controller panel to turn fryer ON, the fryer
equipped with a matchless ignition system and will automatically light the pilot, and heat up to set
temperature.
d. Delighting - wait 5 minutes before attempting to relight the pilot to allow for any gas in the fryer to
dissipate.
WARNING
DO NOT TURN COMBINATION GAS VALVE KNOB TO THE “ON” POSITION UNTIL
VESSEL IS FULL OF WATER OR SHORTENING. TURNING THE KNOB TO “ON” WITH VESSEL
EMPTY WILL DAMAGE THE VESSEL OR COMPONENTS AND VOID WARRANTY.
INITIAL CLEANING
When the fryer is shipped, many of its parts are covered with a thin coat of oil for protection. Before the fryer is ready
for cooking it must be cleaned. This will remove the oil coating and any foreign matter that may have accumulated during
storage and shipment. Perform the cleaning as described below.
a. Fill the tank with water and add one packet of Pitco fryer cleaner or a mild detergent, and turn gas valve knob
to ON position.
b. Computer Controller: Press the button on the controller panel to turn fryer ON. The
fryer will automatically switch into the boil-out mode which will prevent the fryer from
boiling over. Note: do not leave the fryer unattended during this operation. Once the fryer
has heated up to approximately 195
0 F, allow it to operate for 15 minutes to allow any build
up in the tank to soften.
NOTE
Do not leave the fryer unattended during cleaning. Never let the
water level go below the "Min Level" mark on the back of the tank.