Napoleon Fireplaces IR3-1 - Manuel (Page 16)

W415-1198 /05.24.13
16
EN
6.2 OPERATION
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH
THE GLASS DOOR OPENED OR REMOVED.
!
WARNING
MANTEMPTIMER
P1
P2
F
C
am
pm
:
LOW BATTERY
INDICTOR
SIGNAL INDICTOR
TEMPERATURE
DISPLAY
TIME DISPLAY
MODES OF
OPERATION
TIMER DISPLAY
ON/OFF
TEMPERATURE
SETTING
SET BUTTON
OFF BUTTON
LARGE FLAME BUTTON
SMALL FLAME BUTTON
6.2.1 GENERAL REMOTE TRANSMITTER LAYOUT
6.2.2 PROGRAMMING
A. Press and hold the receiver's reset button until you hear two beeps. (First beep is short, second beep
is long.) Release the button after the second beep, refer to "INSTALLATION OVERVIEW" for receiver
location.
B. Within the subsequent 20 seconds press and hold the small fl ame button on the remote transmitter
until you hear two additional short beeps confi rming the code is set, refer to "GENERAL REMOTE
TRANSMITTER LAYOUT". (NOTE: One long beep indicates the sequence has failed or wiring is
incorrect).
NOTE: This is a one time setting only, and is not required after changing the batteries of the remote or receiver.