Napoleon Fireplaces EF30 - Manuel (Page 17)

17
W415-0675 / D / 12.14.11
A. Remove the 7 screws from the bottom half of the
back of appliance illustrated. Remove back plate.
B. Locate the fl ame generation cylinder drum. It is
constructed of two removable halves. They are
two (2) matte black sheet metal pieces with holes
in them, either of which can be removed from the
appliance.
C. Remove the screw as illustrated, that is used to
secure the fl ame generation cylinder drum.
D. Squeeze half of drum cylinder until its top edge
clears the top drum track. Remove the bottom edge
of the cylinder drum from the bottom drum track. This
will give you access to the lamps. NOTE: Do not
exert excessive pressures on the drum cylinder
as this may cause damage.
E. Remove spring clip. Hold socket and pull out old
lamp.
F. Hold socket and push in new lamp (DO NOT exceed
wattage). Replace spring clip.
G. Repeat steps C and D for the second lamp.
H. Insert bottom edge of removed cylinder half into
bottom drum track. Gently squeeze drum cylinder
until its top edge fi t into top drum rack. Reattach the
screw that was removed in step B.
I. Secure the back plate of the appliance to the main
appliance by reattaching the 7 screws removed from
step A.
7.1 FLAME GENERATION LAMP REPLACEMENT
BACK PLATE
Bulbs with Spring
Clips
DRUM LAMP REPLACEMENT
Squeeze
Screw
Flame Generation
Cylinder Drum
FLAME GENERATION CYLINDER
DRUM
3 Screws On
The Back
Mantel
2 Screws
On The
Side
2 Screws
On The
Side
FLAME GENERATION CYLINDER
DRUM
Flame Generation Cylinder
Drum
Flame Generation
Cylinder Drum
Back View of Appliance