Napoleon Fireplaces EF30 - Manuel (Page 15)

15
W415-0675 / D / 12.14.11
Once the appliance has been plugged in to a grounded electrical outlet, it is ready to operate.
A. Plug in your electric appliance.
B. Make sure the appliance's main power button is at the ON position! The remote control will NOT
work if the main Power button is at the OFF position. NOTE: Ensure the house circuit breakers for
the power supply are turned on. In the event of a power failure, when the main switch is in the
ON position and the hand held remote control is in the OFF position, the fl ame generation
lights will come on at the high setting, however the heater remains turned off when the power
is restored.
C. When operating the remote control, it must be directed towards the front of the appliance.
D. The button at the top left corner of the remote is the main power button . Pressing this button
activates the power to the appliance. NOTE: The main power switch on the appliance must be in
the ON position for the remote to operate.
E. To adjust the ember bed brightness, press the “+” or “-” buttons. To increase the ember bed
brightness, press the “+” button, to decrease the ember bed brightness, press the "-" button.
There are seven levels of brightness.
F. To activate the heater, press the button. Press and release the button to cycle through LO, MED,
HI and OFF. Each time the button is pushed, the appliance LED will change to its corresponding
color: Green for LO, Orange for MED, Red for HI, and blank for OFF. The appliance has a built-in
thermostat so it will shut off automatically once the pre-set temperature is reached. It will also turn on
automatically if the room temperature drops below the pre-set temperature.
G. To adjust the height of the fl ame, press the “+” or “-” buttons. To increase the height of the fl ame,
press the “+” button, to decrease the height of the fl ame, press the "-" button. There are seven
levels of fl ame effects.
H. To turn off the appliance, press the button once. NOTICE: This remote control must remain
within 8 meters or 26 feet of the appliance to be effective and this range may be reduced as
battery power is depleted.
REMOTE CONTROL FOR
ELECTRIC FIREPLACE
Indicator
Light
Infrared Ray Exit
-
+
+
-
NOTE: Make sure your batteries are fully charged and installed correctly in your remote control.
6.1 OPERATING BY REMOTE CONTROL