Napoleon Fireplaces EF30 - Manuel (Page 14)

W415-0675 / D / 12.14.11
14
The controls are located on the bottom right corner of the appliance.
A. Plug in your electric appliance.
B. Main ON/OFF Power Switch and LED:
This switch is located on the right side of the control panel. The "|" indicates ON and "O" indicates
OFF.
When the appliance is fi rst turned on, the default settings are as follows:
- Ember bed: HIGH
- Flame: HIGH
- Appliance: OFF
C. Temperature Control Button and LED:
The Appliance LED is located to the right of the FLAME Button. Push the TEMP button to cycle
through different appliance settings. Press and release the TEMP button to cycle through LO, MED,HI
and OFF. Each time the TEMP button is pushed, the Appliance LED will change to its corresponding
color: Green for LO (approximately 16°C / 61°F) , Orange for MED (approximately 22°C / 72°F),
Red for HI (approximately 28°C / 82°F), and blank for OFF. When the appliance is turned on, heat
will emit through the vents located in the middle of the top louvre panel. The appliance has a built-in
thermostat so it will shut off automatically once the pre-set temperature is reached. It will also turn
on automatically if the room temperature drops below the pre-set temperature. NOTE: When the
appliance is turned on for the fi rst time, it may release a slight, harmless odour. This odour is a
normal occurrence caused by the initial heating of the internal heating elements and should not
occur again.
D. Flame Control Button:
This button is located to the right of the TEMP Button. After power is turned on, push the FLAME
control button to adjust the fl ame and ember bed brightness. Press and release the Flame Control
Button to cycle through LO, MED,HI and OFF.
Heater
TEMP FLAME
CONTROLS FOR ELECTRIC
APPLIANCE
Flame Control Button
Remote Control
Receiver
Heater LED
ON/OFF Power
Button
Temperature Control Button
Power LED
6.0 OPERATING INSTRUCTIONS