Napoleon Fireplaces Grandville 42 - BGD42 - Manuel (Page 36)

W415-0777 / E / 08.26.13
36
EN
7.0 OPTIONAL BLOWER INSTALLATION
INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be
electrically connected and grounded in accordance with local codes. In the
absence of local codes, use the current CSA C22.1 Canadian electrical code
in Canada or the ANSI / NFPA 70 National Electrical Code in the United States.
If the appliance was not previously equipped with a blower:
Route a grounded 2-wire, 60hz power cable to the receptacle /
junction box. At this point, it must be strain relieved and insulated.
The three slots on the blower mounting bracket allow ease of adjustment when attaching
the blower. For a quiet running blower, do not allow the assembly to sit on the firebox base.
Slide the vibration reducing pad (A) into the clip (C) and up against the threaded stud (B)
at the other end. The blower must be able to be positioned entirely onto the pad.
To ease installation of the blower, remove the hinge screen and valve control door
(lower louvres) from the base of the appliance.
Tilt the blower onto its side. Slide it past the controls and into the clip (C).
Secure to the threaded stud using the lock washer and wing nut provided.
Ensure that the blower does not touch the appliance base or the firebox.
Attach the connectors from the black and white wires to
the thermal switch and secure the thermal switch bracket
to the bottom left of the unit using the screws provided.
Ensure that the thermal switch touches the firebox wall.
Attach the connectors from the black and red wires to
the blower.
Attach and secure the variable speed switch using the
nut provided. Plug the harness cord into the receptacle
The wire harness provided in this kit is a universal
harness. When installed, ensure that any excess
wire is contained, preventing it from making contact
with moving or hot objects.
Because the blower is thermally activated, when
turned on, it will automatically start approximately
10 minutes after lighting the appliance and will run
for approximately 30-45 minutes after the appliance
has been turned off. Use of the fan increases the output of heat. Drywall dust will penetrate into the blower
bearings, causing irreparable damage. Care must be taken to prevent drywall dust from coming into contact with the
blower or its compartment. Any damage resulting from this condition is not covered by the warranty policy.
white
red
VARIABLE
SPEED
SWITCH
BLOWER
THERMAL
SWITCH
SLOTS ELONGATED
VARIABLE
SPEED
KNOB
51.1
RECEPTACLE /
GROUND
SCREW
JUNCTION BOX
THERMAL SWITCH
A
B
C
!
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK.
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GAS
COMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILL
VOID THE WARRANTY AND CERTIFICATION.
ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
CORD BENEATH THE APPLIANCE.
THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHEN
INSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKING
CONTACT WITH MOVING OR HOT OBJECTS.
51.5