Sony ICD-R100PC - Manuel (Page 53)

53 GB
Additional Information
Error messages
Message
• ”Connection Error“
“Could not communicate with
IC Recorder. Make sure that the
cable is connected properly.”
“Data in IC Recorder has been
modified. Please reconnect.”
• ”Battery Low Error“
“Disconnect the connecting
cable from the IC Recorder, and
replace batteries.”
Problem/Remedy
• The cable is disconnected.
tCheck the connection (pages 12 and 14).
Make sure that the IC recorder is in the
stop mode when making connections.
• Other peripheral devices such as a printer
was connected to the printer port before the
IC recorder was connected.
tRestart the computer. If the message still
appears, change the mode setting of the
printer port (page 55).
• Another program has been set to enable
automatic communication to the printer
port at a certain interval.
tIf such program is set, communication
with the IC recorder cannot be made,
even if nothing is connected to the
printer port. Change the program setting
to disable the automatic communication.
• Malfunction of the IC recorder.
tDisconnect the cable and check to see if
the IC recorder operates properly.
• The ICD-PCLINK Software may not be
used on some computers due to differences
in hardware specifications.
• You have disconnected the cable once and
made some changes on the IC recorder. The
latest data must be transferred to the
computer.
• The batteries in the IC recorder are
exhausted.*
tDisconnect the cable, replace the
batteries with new ones and reconnect
the cable.
Continued