Sony ICD-R100PC - Manuel (Page 15)

Basic Operation
15 GB
If the message “Could not communicate with IC Recorder.
Make sure that the cable is connected properly.” appears
Communication between the IC recorder and the computer was not
successful (Connection Error). Check the following items and start the
procedure from the beginning.
• Is the cable connected properly?
t Check the connection between the cable and the computer (page 12) ,
and between the IC recorder and the cable (page 14).
• Maybe you were using the printer port before starting up the ICD-
PCLINK software, e.g. printing on a printer connected to the printer port.
t Restart the computer. If the message still appears, see
“Troubleshooting” on page 52.
Note
If the “Battery Low Error”message appears, the remaining battery power of the
IC recorder is not sufficient. Disconnect the cable from the IC recorder, replace
both batteries with new ones and connect the cable again. (Even if the
remaining battery indicator on the IC recorder indicates that the batteries are
not exhausted, battery power may not be sufficient for operation with the
computer.)
To detach the cable from the IC recorder
When the data transmission is completed, the ICD-PCLINK main
window (Page 16) appears.