Sony WX-GT90BT - Manuel (Page 25)

25
perform the pairing procedure from the
beginning again.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).
Tip
Connection between this unit and the Bluetooth
device may be automatic, depending on the
device.
Canceling pairing
Perform step 2 to cancel the pairing mode
after this unit and the Bluetooth device are
paired.
Connection
To use the device after pairing is made, start
the connection. Sometimes pairing allows
for connection automatically.
If pairing has already been achieved, start
operation from here.
Connecting a cellular phone
1
Press
 and rotate the control
dial until “BT SIGNL” appears, then
press it.
“
” lights up when Bluetooth signal is
activated.
Note
When the Bluetooth signal for this unit is
already ON, selecting “BT SIGNL” deactivates
the Bluetooth signal.
Tip
You can also output the Bluetooth signal from
this unit by pressing and holding
 on
this unit more than 2 seconds.
2
Turn on the cellular phone and activate
the Bluetooth signal.
3
Connect to this unit using the cellular
phone.
“
” appears when the connection is
made. If you select the Bluetooth phone
source after the connection is made, the
network name and the connected
cellular phone name appear in the
display.
Icons in the display:
* Turns off without handsfree connection.
Differs depending on the cellular phone.
Changing display items
Press
.
Connecting the last-connected cellular
phone from this unit
1
Make sure the Bluetooth signal of the
cellular phone is activated.
2 Press
 repeatedly until “BT
PHONE” appears.
3
Press
 (ENTER).
Signal strength status of
connected cellular phone.*
Remaining battery status of
connected cellular phone.*