Sony STR-DA5200ES - Manuel (Page 122)

122 GB
Setting remote control
codes that are not stored
in the commander
Even if a remote control code is not one of the
presets stored in the remote, it is possible for
the remote to learn the code using the Learning
function.
Note
When setting up the receiver to learn the remote
command modes, replace the batteries with new
ones.
Example for assigning button 1 to VIDEO 1
of the remote:
1
Press TV while pressing RM
SET UP.
The RM SET UP button lights up.
2
Press the input button (VIDEO 1
in the example) for which you
want to use the Learning input
function.
The input button flashes. (The RM SET
UP button remains lit.)
3
Press the button (button 1 in
the example) you want to use as
the VIDEO 1 button.
The input button you selected in step 2
lights up. (The RM SET UP button
remains lit.)
4
Point the remote code receiver
section of the remote toward
the receiver/transmitter on the
remote control to be learned
from.
While the second remote is receiving the
signal, the input button selected in step 2
turns off.
5
The RM SET UP button flashes
twice, then the learning
process is completed.
When the learning process fails, the RM
SET UP button flashes five times. Try to
perform process again from step 2.
6
Press RM SET UP to finish the
Learning function process.
Tips
• When the memory capacity for storing remote
control codes reaches a certain limit, the RM SET
UP button flashes 10 times, and then the learning
process ends.
• If the RM SET UP button flashes five times in step
1, and the learning process does not start, replace
the batteries with new ones.
To cancel learning
Press RM SET UP. Also, not pressing any
button for 60 seconds cancels the settings.
2
1
1,6
About 5 cm - 10 cm (2" - 4")