Sony STR-DA5200ES - Manuel (Page 109)

109 GB
O
the
r O
p
erati
ons
Operating without a GUI
(Graphical User
Interface)
You can operate this receiver using the display
even if you do not use a GUI when a TV
monitor is not connected.
Press ON SCREEN to switch to
“GUI OFF” when “GUI ON” appears
on the display.
For details on the auto calibration, see “9:
Calibrating the appropriate settings
automatically (AUTO CALIBRATION)”
(page 42).
Refer to “Before you perform the auto
calibration” (page 42) before performing the
auto calibration.
To operate on the receiver
1
Press ON SCREEN to set the GUI
display mode to off.
The menu appears on the TV screen when
“GUI ON” appears on the display.
2 Press RECEIVER.
Receiver operation is enabled.
3 Press MENU.
“Auto Calibration” is displayed.
4
Press .
5 Press V/v repeatedly to select a
position number to be used, then press
.
6
Press V/v repeatedly to select “AUTO
CAL START?,” then press to start
the measurement.
Measurement starts in five seconds. A
count down appears on the TV screen.
Note
While the time is counting down, stand away
from the measurement area to avoid
measurement error.
7 Measurement starts.
The measurement process will take
approximately 30 seconds. Wait until the
measurement process completes.
To cancel auto calibration, change the volume,
switch INPUT SELECTOR, change the
speaker setting of the receiver, connect
headphones, turn the muting on, or press ON
SCREEN.
Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set this value from “Surround position.” settings in
the Auto Calibration settings menu (page 72).
Tips
• Operations other than turning the receiver on or off
are deactivated during auto calibration.
• In the following situations, the measurements may
not be performed correctly or auto calibration
cannot be performed.
– when special speakers, such as dipole speakers
are used.
– when the multi zone function is used in zone 2.
To confirm/save auto calibration
when GUI function is turned off
1 Confirm the measurement result.
When the measurement ends, a beep
sounds and the measurement result appears
on the display.
Performing auto calibration
Measurement
result Display Explanation
When the
measurement
process
completes
properly COMPLETE Proceed to step
2.
When the
measurement
process fails ERROR
CODE XX See “Message
list after auto
calibration
measurement”
(page 46).
continued