HP Photosmart Pro B8850 Printer - Manuel (Page 7)

4 USB port: Use this port to connect the printer to a computer.
5 Rear door releases: Press the two releases on either side of the rear paper slot to remove the rear door.
Paper trays
1 Main tray: Place a stack of photo paper, plain paper, or other non-rigid media in this tray for printing. Load the media in
portrait orientation and with the side to be printed facing down. Squeeze the main tray release to lengthen or shorten
the main tray, depending on the size of paper you are loading.
2 Output tray: Print jobs come out here. For easier access to the main tray, remove this tray by pulling it out towards you.
3 Specialty media tray (open): Insert a single sheet of heavy media, such as card stock, in this tray. Media from this tray is
fed straight through the printer without being bent. Load the media with the side to be printed facing up. Do not load media
thicker than 0.7mm. To learn how to use this tray, see
Print from the specialty media tray (single-sheet feed) .
Main tray
1 Paper-width guide: Adjust this guide to fit close to the left edge of the paper in the tray by pressing the button on the front
of the guide and sliding the guide across.
2 Paper-size markings: Refer to these markings to guide you for loading paper in the correct orientation.
3 Main tray extension: Extend the main tray to load larger sizes of paper. Fully extended, the main tray can hold up to 33 x 48.3
cm (13 x 19 inch) paper.
4 Main tray release: Squeeze this release and pull it towards you to extend or retract the main tray extension, or to remove
the tray from the printer.
5 Paper stops: Align the paper against these stops so that the paper feeds correctly into the printer.
6 Paper-length guide: Adjust this guide to fit close to the end of the paper in the tray.
Chapter 1
4 Welcome
E
n
glish