Bosch HIIP054U - Manuel (Page 43)

English 40
Service
Self Help
Cooktop Troubleshooting
Use these suggestions before calling for service to avoid
service charges.
.
9 WARNING
Repairs should only be done by a trained
servicer.
Improper repair of your appliance may result in
risk of severe physical injury or death.
Cooktop Problem Possible Causes and Suggested Solutions
none The electric power supply has been
cut off.
Use other electrical appliances to check whether
there has been a power cut.
The appliance has not been cor-
rectly connected following the con-
nection diagram.
Check that the appliance has been connected
correctly according to the connection diagram.
Electronic system malfunction. If the measures above cannot resolve the mal-
function, contact the Technical Assistance Ser-
vice.
The indicators flash The control panel is damp or an
object is resting on it.
Dry the control panel area or remove the object.
The indicator - flashes
on the cooking zone
indicators
A fault has occurred in the electronic
system.
Briefly cover the control panel with your hand to
confirm the malfunction.
“§ + number / š +
number / ¡ + number
Electronic system malfunction. Unplug the cooktop from the mains. Wait about
30 seconds before plugging it in again.*
”‹ / ”Š There is an internal operating error. Unplug the cooktop from the mains. Wait about
30 seconds before plugging it in again.*
”ƒ The electronic system has over-
heated and the corresponding
burner has been turned off.
Wait until the electronic system has cooled down
sufficiently. Then touch any symbol on the cook-
top. *
”… The electronic system has over-
heated and all burners have been
turned off.
Ӡ + power level and
beep
There is a hot pan on the control
panel. It is highly likely that the elec-
tronic system will overheat.
Remove that pan. The malfunction indicator will
turn off shortly afterwards. You can carry on
cooking.
Ӡ and beep There is a hot pan on the control
panel. The burner has turned off to
protect the electronic system.
Remove that pan. Wait a few seconds. Touch any
key on the control panel. When the malfunction
indicator turns off, you can carry on cooking.
—‚ Incorrect supply voltage, outside
normal operating limits.
Contact your electricity distributor.
—ƒ / —„ The burner has overheated and has
turned off in order to protect its
cooking surface.
Wait until the electronic system has cooled down
sufficiently before turning it back on.
* If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.