LiftMaster 8360 Premium Series DC Battery Backup Capable Chain Drive - Manuel (Page 7)

7
1 Press and release the Learn button on the garage
door opener. The Learn indicator light will glow
steadily for 30 seconds.
2 Within 30 seconds, press and hold
the button on the remote control.
3
Release the button when the
garage door opener light blinks.
It has learned the code. If light
bulbs are not installed, two
clicks will be heard.
PROGRAM A REMOTE USING THE LEARN BUTTON ON THE GARAGE DOOR OPENER
When replacing the light lens cover, ensure the antenna wires are hanging straight down.
Learn
Indicator
Light
Yellow
Learn
Button
Your garage door opener has been programmed at the factory to operate with your remote control. Older LiftMaster remote controls are NOT compatible. Programming can be done
through the door control or the Learn button on the garage door opener. To program additional remote controls refer to the instructions provided with the additional remote controls or visit
www.liftmaster.com. If your vehicle is equipped with a Homelink
® , you may require an external adapter depending on the make, model, and year of your vehicle. Visit www.homelink.com for
additional information.
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1 Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ ® enabled accessories)
1 Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2 Immediately press and hold the learn button again until the learn LED goes out. All codes
are now erased.
Reprogram any accessory you wish to use.
Programming - Remote Controls
Operation