LiftMaster 8360 Premium Series DC Battery Backup Capable Chain Drive - Manuel (Page 5)

5
Operation
Using the Door Control PUSH BAR
Press the push bar to open and close the door.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are
turned on they will stay on until the LIGHT button is pressed again, or until the garage door
opener is activated. Once the garage door opener is activated the lights will turn off after
the specifi ed period of time (the factory setting is 4-1/2 minutes). The LIGHT button will not
control the lights when the door is in motion. The duration of the light timing can be adjusted
using the door control, see page 6.
The following features are accessible by lifting the push bar:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or MyQ ® accessories can be
programmed to the garage door opener by pressing the Learn button.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote
controls while still allowing activation from the door control and keyless entry. This feature is
useful for added peace of mind when the home is empty (i.e. vacation).
AUTOMATIC LIGHT
Motion Sensor (Motion-Detecting Control Panel)
Factory default is set to on. This feature automatically turns on the garage door opener lights
when motion is sensed. The lights will come on for the set period of time, then shut off. If
using the garage door opener light as a work light disable the motion sensor, otherwise the
light will turn off automatically if you are beyond the range of the sensor.
Light Feature
The lights will turn on when someone enters through the open garage door and the safety
reversing sensor infrared beam is broken.
MAINTENANCE ALERT SYSTEM (MAS)
This feature assists the homeowner in ensuring the garage door opener system stays in
good working condition. When the garage door opener needs to be serviced (approximately
4500 garage door opener cycles) the command (yellow) and service (red) LEDs will begin
to alternately fl ash back and forth. The factory setting for the MAS feature is off and can be
activated at time of installation. Contact your installing dealer for service.
Push Bar
Light Button
MOTION-DETECTING CONTROL PANEL
The control panel will vary depending on the garage door opener model purchased.
MULTI-FUNCTION CONTROL PANEL
Service LED
LEARN Button
LOCK Button
Light Button
Service LED
Push Bar
LEARN Button
LOCK Button
Command LED
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the
garage door opener activates (it may take up to 3 presses). Test the door control by
pressing the push bar, each press of the push bar will activate the garage door opener.