LiftMaster 8360 Premium Series DC Battery Backup Capable Chain Drive - Manuel (Page 6)

6
Features
Lock NOTE: Your remote controls will NOT work when LOCK mode is active however your keyless entry will still allow access to your
garage.
Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your
handheld remote control will not operate your door at this time.
Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing and normal operation will
resume.
Light To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights fl ash.* The time interval is indicated by the number of fl ashes.
To cycle through the time intervals repeat the step above.
Deactivate: Press and hold the LIGHT button until the garage door opener lights turn on, then off again.*
Activate: Start with the garage door opener lights on. Press and hold the LIGHT button until the garage door opener lights turn off, then
on again.*
* Approximately 10 seconds
Motion Sensor
(Motion-Detecting
Control Panel) Activate/Deactivate: Slide the motion sensor switch ON or OFF.
To Program a
Remote Control or
Keyless Entry 1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will fl ash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identifi cation number (PIN) of your choice on the keyless entry keypad. Then press the ENTER
button.
The garage door opener lights will fl ash (or two clicks will be heard) when the code has been programmed. If programming is
unsuccessful, repeat steps 1-3 or program the remote using the learn button on the garage door opener.
Maintenance Alert
System (MAS) Activate/Deactivate
Press and hold the LEARN button. Then press the LIGHT button. The service LED will fl ash the status; Active is 2 fl ashes and
deactivated is 3 fl ashes.
Programming
NUMBER OF TIMES GARAGE DOOR OPENER LIGHTS FLASH 1 2 3 4
TIME THE GARAGE DOOR OPENER LIGHT STAYS ON 1 ½ Minutes 2 ½ Minutes 3 ½ Minutes 4 ½ Minutes
Operation
Motion Sensor Switch
Service LED
LEARN
Button
LOCK
Button
Motion
Sensor
LIGHT
Button
Command
LED
Service
LED
LEARN
Button
LOCK
Button
LIGHT
Button
Command LED
MULTI-FUNCTION
CONTROL PANEL
MOTION-DETECTING
CONTROL PANEL