CAMPO EQUIPMENT BLAZE 800 D/G - Manuel (Page 22)

CAMPO EQUIPMENT CO. LTD. (ECOBLAZE)
6 Carson Court, Brampton, ON, CANADA, L6T 4P8
Tel: (905) 793-2525 | Fax: (905) 793-8768 | www.campoequipment.com
CHANGING BURNERS ON THE BLAZE 800 D/G
1.) MAKE SURE “MAIN SWITCH” IS IN “OFF” POSITION AND DISCONNECT MAIN POWER
SUPPLY.
2.) IF BECKETT CF800 OIL BURNER IS CURRENTLY INSTALLED AND GAS OPERATION WITH
THE CG10A IS DESIRED DISCONNECT FUEL LINE AT BURNER PUMP “INLET” AND
DISCONNECT FUEL LINE FROM “RETURN” PORT ON BURNER PUMP.
3.) DISASSEMBLE FILTER BRACKET AND FILTER ENTIRELY FROM BURNER COMPARTMENT.
4.) DISCONNECT WIRE HARNESS.
5.) REMOVE THE (4) 5/16” NUTS HOLDING THE BURNER.
6.) REMOVE ENTIRE BECKETT CF800.
7.) MOUNT CG10A TO (4) 5/16” BOLTS (WITH GAS TRAIN CONNECTED) AND FASTEN (4) 5/16”
NUTS.
8.) FASTEN GAS TRAIN SUPPORT BRACKET TO INLET SIDE OF TRAIN.
9.) CONNECT WIRE HARNESS.
10.) SWITCH FROM “OIL” TO “GAS” ON THE MAIN CONTROL PANEL.
REVERSE THE ABOVE STEPS FOR GAS TO OIL OPERATION.