Amana ARG7302 Manuel d'utilisation

Page 10

Advertising
background image

10

Converting Oven Burner for Use with LP\Propane
1.

Remove storage drawer.
• See

Removing Storage Drawer section.

2.

Locate and remove 2 screws attaching Z-shaped
cover plate.
• Cover plate located in center, rear of storage drawer

cavity.

• Removing cover plate exposes oven burner orifice

and air shutter.

3.

Turn orifice hood clockwise until snug.
• Do not overtighten orifice hoods. Orifice hoods can

strip.

4.

Replace cover plate and storage drawer.

A

B

C

A—Air Shutter Screw
B—Orifice Hood
C—Air Shutter

Converting Oven Burner

Converting Broiler Burner for Use with LP\Propane
1. Locate orifice spud attached adjacent to pressure

regulator and remove for later use.
• Orifice spud used for LP/propane gas is silver and

is stamped “58”.

2.

Open oven door and locate broiler burner on oven
ceiling.
• Remove oven door to make conversion easier. See

Removing Oven Door section.

3.

Remove 2 screws securing front of burner to oven
ceiling and remove broiler.
• Be careful not to damage ignitor while removing

broiler.

4.

Unscrew natural gas burner spud stamped “52”

with

5

/

16

inch socket wrench and replace with LP/

propane burner spud stamped “58”.
• Attach unused burner spud near regulator for future

use.

5.

Reinstall broiler and, if necessary, oven door.

A

B

C

A—Screw
B—Broiler
C—Spud/Oriface

Converting Broiler Burner

Converting Type 1 Pressure Regulator for Use with
Natural Gas
1.

Remove pressure regulator cap with a

wrench.

2.

Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.

3.

Reverse plastic insert and carefully push plastic insert
firmly into hole in pressure regulator cap.
• Insert must show “NAT” or be blank.

4.

Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of regulator.

Converting Type 2 Pressure Regulator for Use with
Natural Gas
1.

Remove pressure regulator cap with a wrench.

2.

Reverse pressure regulator cap.
• Insert shows “NAT” or is blank.

3.

Place pressure regulator cap on pressure regulator
and tighten.

Advertising