Burkert Type BBS-10 - Manuel (Page 4)

8
6.6. Disassembly
Disassembly is in reverse sequence to assembly.
7. START-UP
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
product and the surrounding area.
• Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may start up the equipment/the
product.
• Following assembly, ensure a controlled restart.
• When starting up the equipment, ensure that no unauthorized
voltage increases and pressure surges can occur.
NOTE!
Damage to the sealing elements when cleaning the pipeline
systems.
• Clean the pipeline systems preferably with a cleaning agent which
does not damage the sealing elements.
• Do not clean with wire brushes or machines which cause abrasion
of the surface.
• When using mechanical pipeline monitoring devices, ensure
that they do not damage the sealing elements (also the sealing
contour).
Damaged sealing elements must be replaced!
english
9
8. MAINTENANCE
WARNING!
Danger – high pressure and discharge of medium!
• Before loosening the nuts or screws, always turn off the pressure
and relieve the lines.
• Wear protective equipment if media is hazardous.
• Nuts or screws may be retightened on pressurized lines only by
technicians in consideration of special precautions.
• When shutting down the equipment, ensure that no unauthorized
voltage increases and pressure surges can occur.
• Following maintenance, ensure a controlled restart.
Have the product serviced regularly by technicians!
We recommend a maintenance interval of 6 months.
Inspection and maintenance work includes in particular monitoring and
ensuring the
• leak-tightness,
• identification,
• proper mode of operation of the safety and warning devices.
9. SPARE PARTS
CAUTION!
Risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable spare parts may cause injuries
and damage the product and the surrounding area.
• Use only original accessories and original spare parts from Bürkert.
The spare part set for the ball check valve Type BBS-10 includes:
Support flange, spring, locking ball, O-ring.
The order numbers for the spare part sets can be found on the corre-
sponding data sheet on the Internet.
english
10
10. RECOMMENDED AUXILIARY
MATERIALS
In this manual the following auxiliary materials are recommended for
faultless operation, maintenance and repair of the device:
Type of auxiliary
material
Product designation Manufacturer and
Internet address
Mounting paste Mounting paste
Klüber UH1 96-402
Klüber Lubrication
www.klueber.com
11. TRANSPORTATION, STORAGE,
DISPOSAL
NOTE!
Transport damage!
Inadequately protected filter screens and O-rings may be damaged
during transportation.
• Transport the filter screen in a firmly assembled state, protected
against moisture and dirt, in shock-resistant packaging.
Incorrect storage may damage the product.
• Prevent the temperature from exceeding or dropping below the
permitted storage temperature.
• Store the product in a dry and dust-free location!
• Store O-rings dry and protected from UV radiation and for not
longer than 3 years.
• Storage temperature -40 to +80°C.
Damage to the environment caused by product components
contaminated with media.
• Dispose of the product and packaging in an environmentally friendly
manner!
• Observe applicable disposal and environmental regulations.
english
Type BBS-10