Candy PVI 4100 - Manuel (Page 66)

66 -
The hob does not operate.
The hob does not cut off
The hob stops automatically
Frequency of on/off operations
for cooking zones
The hob does not operate or cer-
tain zones don’t work
“H” display, residual heat
indicator, blinking
• A big spill or object covers at least two buttons, for
at least 10 seconds. Clean up the spill or remove the
object.
• The control panel is locked. Press the “Locking”
button to release.
• The control panel is locked. Press the “Locking”
button to release. Refer to the section, “Operating
time” page 61.
• A spill covers at least two buttons for more than
10 seconds; the hob switches to safety, and an audible
beep sounds so long as the buttons are covered. Clean
up the spill or remove the object.
• The cooking zones stop automatically if they are
left on for too long. Refer to the section, “Operating
time” page 61.
• The on-off cycles vary according to the required
heat level:
- low level: short operating time,
- high level: long operating time.
• The shunts are not positioned correctly on the
terminal board. Have a check made that the
connection is done in compliance with the
recommendations, page 50 & 51.
• The electronic temperature is too high. A technician
should verify the fitting in compliance with the
recommendations, page 52 & 53.
PROBLEMS AND SOLUTIONS