Rival S16SG-CN - Manuel (Page 5)

-E5-
4. To change the temperature, turn CONTROL KNOB to desired
setting. Turning the CONTROL KNOB clockwise will increase the
temperature. Turning the CONTROL KNOB counter-clockwise will
decrease the temperature. Temperature can be adjusted from
150°F/70°C - 425°F/220°C in 25° increments.
5. As the skillet heats up, the display will show the actual temperature
of the skillet as it climbs to reach the set temperature.
6. When the desired temperature has been reached, the PREHEAT
LIGHT will turn off, the READY LIGHT will turn on and the skillet will
beep three times.
NOTE: If you adjust the temperature during cooking, the PREHEAT
LIGHT will turn on. When the new temperature is reached, the
PREHEAT LIGHT will turn off and the READY LIGHT will turn on
again and the unit will beep three times.
7. Your skillet is equipped with a digital countdown timer. To switch
the display into timer mode, press the TEMP/TIMER button once. The
display will show 00:00 as the default countdown time.
8. Turn the CONTROL KNOB clockwise to select the desired time.
Turning the CONTROL KNOB counterclockwise will decrease the
time. The timer can be adjusted from zero to sixty minutes in 1
minute increments.
9. The countdown timer will start counting down 3 seconds after the
timer has been set. The timer will count down in one second
increments.
10. When the timer counts down to 00:00, the unit will beep three
times, but will continue to operate at the current temperature.
You may adjust the countdown timer during cooking in 1
minute increments. For example, if the timer reads 23:24 and
you turn the CONTROL KNOB one click clockwise, it will move
up to 24:00. It will decrease in 1 minute intervals if you turn the
knob counter-clockwise.
11. When the TIMER is used, the TIMER will be the default display. If
you wish to switch back to the temperature display, press the
TEMP/TIMER button once. To switch back to the timer display,
press the TEMP/TIMER button again.
12. To change the temperature scale from Fahrenheit and Celsius,
simply insert a pen or paper clip in the hole located on the upper
HOW TO USE YOUR ELECTRIC SKILLET (CONT.)