Rose electronic Crystal View - Manuel (Page 17)

SYSTEM OVERVIEW
CrystalView Installation and Operations Manual
11
Changing SW1 position 2 can change the default “Hot Key” from the right control
key to the left control key.
See Table 3 for the ”Hot Key” summary.
If you need advice in designing your system layout or have a special request,
contact Rose Electronics by phone or e-mail to discuss your particular remote
accessing needs.
The CrystalView uses a “Hot Key” that establishes communication to the
CrystalView and not the CPU. The default “Hot Key” is the right control key.
To communicate instructions to the CrystalView, press and release the “Hot
Key” and within 2 seconds issue the needed command.
Example:
If you want to enter the Private Mode on a Dual model CrystalView, first press
and release the right control key and within 2 seconds press the Scroll Lock
key. This will place the unit in the Private mode. To exit the private mode,
press and release the right control key and within 2 seconds, press the Scroll
Lock key again.