Lenovo 1044 - Manuel (Page 56)

To install the battery card assembly onto the RAID controller, do the following:
a. Note the top view and bottom view of the battery card assembly. Then, insert the battery pack
harness connector into the J4 battery pack harness connector on the backside of the battery card
assembly. For more information, refer to the following illustrations.
Figure 32. Top view of the battery card assembly
1 Battery pack harness
Figure 33. Bottom view of the battery card assembly
1 J4 battery pack harness connector
2 J5 board-to-board connector
3 J2 connector
b. With the front side up, place the RAID controller on a flat, clean, static-free surface.
46 ThinkServer Installation and User Guide