Lenovo 1044 - Manuel (Page 47)

5. Remove the PCI card from the PCI card slot on the riser card.
Figure 25. Removing the PCI card from the riser card
If you are instructed to return the PCI card, follow all packaging instructions and use any packaging materials
that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to “Completing the parts replacement” on page 64.
Removing or installing the Ethernet card
This section provides instructions on how to remove or install the Ethernet card.
Removing the Ethernet card
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 17.
This section provides instructions on how to remove the Ethernet card.
The Ethernet card is installed on the riser card. To remove the Ethernet card, do the following:
Note: Use any documentation that comes with the Ethernet card and follow those instructions in addition to
the instructions in this section.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 19.
3. Disconnect any cables that impede access to the riser card.
4. Remove the riser card together with the installed Ethernet card. See “Removing the riser card” on
page 33.
5. Refer to “Removing a PCI card” on page 36 and follow those instructions to remove the Ethernet
card from the riser card.
6. If you are instructed to return the Ethernet card, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
Chapter 5 . Installing, removing, or replacing hardware 37