KITCHENAID KGRA806 - Manuel (Page 12)

12
Start
The START pad begins any oven function except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, “START?” will appear on the oven display as
a reminder. If not pressed within 5 minutes after pressing a pad,
the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
Control Lock
The Control Lock shuts down the control panel pads to prevent
unintended use of the oven. The Control Lock is preset unlocked,
but can be locked.
When the control is locked, only the TIMER SET/START and
TIMER OFF pads will function.
To Lock/Unlock Control: Before locking, make sure the oven,
the Timer and Timed Cooking are off. Press and hold the START
pad for 5 seconds until “CONTROL LOCK” appears on the
display. Repeat to unlock and remove “CONTROL LOCK” from
the display.
Off
The OFF pad stops any oven function except for the Clock, Timer
and Control Lock.
Clock/Timer Display
This is a 12-hour clock.
1. Press CLOCK SET/START.
2. Press number pads to set time of day.
3. Press CLOCK SET/START
OPTIONS
Options Selection Pad
The OPTIONS selection pad allows you to access special
functions within the Electronic Oven Control that allow you to
customize the product to your needs. These special functions
allow you to change the oven temperature between Fahrenheit
and Celsius, turn the audible signals and prompts on and off, and
adjust the oven calibration. The Sabbath Mode is also set using
the OPTIONS selection pad.
To Use: Press OPTIONS. The oven display will scroll through the
various options, starting at 1 and ending in 0. You can also press
the OPTIONS selection pad and number pad to quickly access
the desired hidden function.
Fahrenheit and Celsius
Press options, then 1 on the keypad for Celsius. Repeat to
convert back to Fahrenheit.
Tones
Tones are audible signals, indicating the following:
One beep
■ Function has been entered
Three beeps
■ Invalid pad press
Timer Completion Tones
Three chimes occur when the timer reaches zero. This can be
when using the timer for functions other than cooking.
Cooking Time Completion Tones
Three beeps indicate the end of a cooking cycle.
To turn On/Off: Press OPTIONS, and then 4 to turn ON. Press
OPTIONS, and then 4 to turn OFF.
Preheat Completion Tone
One chime indicates a preheat cycle has been completed.
All Tones
All tones are preset ON, but can be turned OFF. To turn tones ON,
press the options key, then press keypad 2. To turn tones OFF,
press the options key again, and then press keypad 2.
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Press OPTIONS, and then 3 to lower the volume.
Press options 3 to raise the volume of the tones.
Oven Temperature Calibration
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door during cycling may
give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
A minus sign means the oven will be cooler by the displayed
amount. The absence of a sign means the oven will be warmer by
the displayed amount. Use the following chart as a guide.
To Adjust Oven Temperature Calibration:
1. Press OPTIONS, and then 6 to set the calibration.
2. Press 3 to increase the temperature, or press 6 to decrease
the temperature.
3. Press START to end calibration.
OPTIONS SPECIAL FUNCTION
1 Fahrenheit and Celsius conversion
2 Tones On/Off
3 Tones High/Low
4 Cooking Time Completion Tones On/Off
6 Oven temperature calibration
7 Sabbath Mode
ADJUSTMENT °F (AUTOMATIC
°C CHANGE) COOKS FOOD
10°F (5°C) ...a little more
20°F (10°C) ...moderately more
30°F (15°C) ...much more
-10°F (-5°C) ...a little less
-20°F (-10°C) ...moderately less
-30°F (-15°C) ...much less