HP Vectra VL 5/xxx - Manuel (Page 51)

English 41
3 Troubleshooting Your PC
If Your PC Does Not Start Properly
If You Cannot Start Your PC from a Modem
If you are running Windows 95 and you have chosen the option to start
your PC from a modem, and this option does not work, then you need
to change the IRQ setting in the HP Setup program.
In the Setup program, go to the Security group, and the “Start-up
Center” submenu. Change the IRQ setting for the setup item “Start
from Modem”. (Refer to "HP Setup Program", on page 60.)
If a POST Error Message is Displayed
The Power-On-System-Test (POST) can detect both an error and a
change to the configuration. In either case, an error code and short
description is displayed. Depending on the kind of error, you will have
one or more of these choices available on screen:
• Press to ignore the message and continue.
• Press to run Setup and correct a system configuration error. HP
recommends that you correct the error before proceeding, even if
the PC appears to start successfully.
• Press to accept (validate) the change and update Setup’s
configuration information.
• Press to see more details about the message. After viewing
these details, you will be returned to the original POST display
screen. If the message is actually a change to the configuration you
have made (for example, you have just removed some memory), you
can then press
to accept the change and update Setup’s
configuration information. Otherwise, press to ignore the
message and continue, or press to run Setup and correct a
system configuration error. (The number of choices you will have
available are dependent on the kind of error.)