HP Vectra VL 5/xxx - Manuel (Page 40)

2 How to Install Accessories In Your PC
Installing Mass Storage Devices
30 English
Installing a Flexible Disk Drive, CD-ROM Drive, or Tape Drive
WARNING To take care to avoid electric shock and harm to your eyes by laser light
from a CD-ROM drive, do not open the CD-ROM drive enclosure. The
drive should be serviced by authorized service personnel only.
1 Switch off the display and computer, and disconnect the power
supply cables and any telecommunications cables.
2 Remove the computer’s cover (see page 17).
3 Remove the airflow guide (refer to page 18), if necessary.
4 Remove the small cover plate on the shelf by unsnapping it first from
the right side, and then pulling it out.
5 Check that the mounting rails are attached to the device with the
screws provided.
6 Slide the drive completely into the shelf.
7 Connect the power and data cables to the rear of the device (the
connectors are shaped to go in one way only). See “Internal
Connectors” on page 26 for more information about which
connectors to use.
8 Secure the device in position using the screws provided with the
device.
9 To allow access to the device, remove the relevant shelf cover plate
from the cover by pulling the plate from the left and unhinging its
right-hand side. Store it in a safe place.
10 Install any other accessories before replacing the airflow guide and
cover.