HP Vectra VL 5/xxx - Manuel (Page 43)

English 33
2 How to Install Accessories In Your PC
Installing Accessory Boards
Refer to the documentation supplied with the operating system for
details on your operating system’s capabilities and restrictions
concerning how to configure non-Plug and Play accessory boards.
Installing the Board
1 Switch off the display and computer, and disconnect the power
supply cables and any telecommunications cables. Remove the
computer’s cover.
2 Remove the airflow guide (refer to page 18), if necessary.
3 Find a free accessory board slot with the correct type of connector
socket (PCI or ISA). Some boards may have preferred locations, in
which case special installation instructions should be detailed in
their manuals.
NOTE Your PC may have a small terminator board installed in a PCI slot. You
must remove this board before installing any PCI accessory boards.
4 Unscrew and remove the accessory board slot cover. Store it in a safe
place. If the slot cover is tight, loosen the screws on the adjacent
slots.
5 Hold the board vertically with the connector towards the socket.
Slide it into the free slot from which you have just removed the slot
cover. Do not bend the board.
Step 4: Unscrew and
remove the accessory
board slot cover. Step 5: Slide the board into a
free slot.